Another Time Lapse of a Channel Logo on Laser engraver
I was given another opportunity and permission to engrave the channel logo from GameDad. This took around 5 hours to run on a modified Eleksmaker A3 Pro Frame and a 10w Endurance Laser. It is a time-lapse down to just under 4 minutes. Please Enjoy.
POWER CABLE OUT FIRST BEFORE ANYTHING
Here is how to wire up Endurace laser with an Eleksmaker MANA board.
You will need to cut the end off the laser wire and strip the wire ends. Only black & Yellow
Laser Cable
You will only need black and yellow. i have cut the red short so dose not get in the way at all.
As you can see the red from the endurance laser goes to the yellow and black to black.
This is the 10Watt laser i am useing for this write up but the same applies for the lower as well.
Dont forget to have all power off when doing this his here a video to show u with 2.1 and 10watt.